Sigenergy Hardware
The following hardware should work with Energy Manager. Please note that different models and firmware versions can behave differently so some small configuration changes may need to be made to make a specific model work correctly. Not all models have been tested.
⚠️Draft compatibility list
This is a draft compatibilty list. These models should work but are in no way guaranteed until they have been reported as working.
Single-phase models
- Sigen Hybrid Series
- 5kW, 6kW, 8kW, 10kW (battery-ready)
Three-phase models
- Sigen Hybrid Series
- 5kW through 30kW (battery-ready)
- SigenStor EC Series
- SigenStor EC 5.0 TP (5.0 kW)
- SigenStor EC 6.0 TP (6.0 kW)
- SigenStor EC 8.0 TP (8.0 kW)
- SigenStor EC 10.0 TP (10.0 kW)
- SigenStor EC 12.0 TP (12.0 kW)
- SigenStor EC 15.0 TP (15.0 kW)
- SigenStor EC 17.0 TP (17.0 kW)
- SigenStor EC 20.0 TP (20.0 kW)
- SigenStor EC 25.0 TP (25.0 kW)
Batteries
- SigenStor BAT 5.0 (5kWh modules)
- SigenStor BAT 8.0 (8kWh modules)
Other requirements
Option 1
- Sigen Gateway HomeMax SP (with built-in CTs)
Option 2
- Sigen Gateway Home SP (plus a Sigen Sensor TP DH/AU)
Notes
Installer Requirements
- Modbus TCP must be enabled by certified installer
- Device ID configuration and screenshot confirmation
- Network connectivity setup (Ethernet recommended)
ℹ️Important
Not all of these hardware models have been tested, but should work. Any that are found to NOT work will be removed the moment it is discovered.